dsPIC33FJXXGSXXX SMPS & Digital Power Conversion 16-bit Digital Signal Controller. These devices offer features supporting common, multi-loop digital switch-mode power supplies (SMPS) and other digital power-conversion applications such as: • AC to DC Converters • DC to DC Converters • Power Factor Correction (PFC) • Uninterruptible power supply (UPS) • Inverters • Embedded Power-Supply Controllers • Circuit Breakers, Arc Fault Detection • Digital Lighting

Parameter Name	Value
Architecture	16-bit
CPU Speed (MIPS)	40
Memory Type	Flash
Program Memory (KB)	6
RAM Bytes	256
Temperature Range C	-40 to 125
Operating Voltage Range (V)	3 to 3.6
I/O Pins	13
Pin Count	18
System Management Features	BOR
POR	Yes
WDT	Yes
Internal Oscillator	7.37 MHz, 32 kHz
nanoWatt Features	Fast Wake/Fast Control
Digital Communication Peripherals	1-UART, 1-SPI, 1-I2C
Analog Peripherals	1-A/D 6x10-bit @ 2000(ksps)
Comparators	0
USB (ch, speed, compliance)	0, None,
CAN (#, type)	0 None
Capture/Compare/PWM Peripherals	/1
PWM Resolution bits	16
Motor Control PWM Channels	4
Timers	2 x 16-bit
Parallel Port	GPIO
Hardware RTCC	No
DMA	0

Up to 40 MIPS Operation (at 3.0-3.6V)

            16 x 16 Fractional/Integer Hardware Multiply, Single Cycle Execution

            Single-Cycle Multiply and Accumulate

            32-bit by 16-bit Hardware Divider

            C Compiler Optimized Instruction Set

System

            Internal oscillator and Phase-Locked Loop (PLL) with 120 MHz VCO

            On-chip LDO Voltage Regulator

            JTAG Boundary Scan and Flash Memory Program Support

            Fail-Safe Clock Monitor – allows safe shutdown if clock fails

            Watchdog Timer with separate RC oscillator

Power Managed Modes

            Run, Idle and Sleep modes

            Multiple, Switchable Clock Modes for Optimum Performance and Power Management

High-Speed PWM Module Features

            Up to Four PWM Generators with Four to Eight Outputs

            Dead Time for Rising and Falling Edges

            Duty Cycle Resolution of 1.04 ns for Dead-Time, Phase Shift, and Frequency

            Supported PWM modes: Standard Edge-Aligned, True Independent Output, Complementary, Center-Aligned, Push-Pull, Multi-Phase, Variable Phase, Fixed Off-Time, Current Reset, and Current-Limit

            PWMxL, PWMxH Output Pin Swapping

            PWM4H, PWM4L Pins Remappable

            On-the-Fly PWM Frequency, Duty Cycle and Phase Shift Changes

High-Speed Analog Comparator

            Up to Four Analog Comparators

            20 ns response time

            10-bit DAC for each analog comparator

            DACOUT pin to provide DAC output

High-Speed 10-Bit ADC

            10-Bit Resolution

            Up to 12 Input Channels Grouped into Six Conversion Pairs

            4 Msps or 2 Msps Conversion rate

            Independent Trigger Source Section for each Analog Input Conversion Pair

Peripherals

            UART Module with LIN and IrDA® support

            SPI Module with FIFO

            I2C™ Modules with Master and Slave Modes

            Up to 3 16-bit Timer Modules

            Up to 2 Input Capture and 2 Output Compare / PWM

dsPIC33FJ06GS101/X02 and dsPIC33FJ16GSX02/X04 Data Sheet